空氣濾清器的作用是吸入空氣中的灰塵被阻隔在濾清器中,以避免壓縮機被過早的磨損和油分離器被阻塞,通常在運轉1000個小時或一年后,要更換濾芯,在多灰塵地區,則更換時間間隔要縮短。濾清器維修時必須停機,為了減少停車時間,建議換上一個新的或已清潔過的備用濾芯?！ ∏鍧崬V芯步驟如下： 1、對著一個平的面輪流輕敲濾芯的兩端面,以除去絕大部分重而干的灰沙?！ ?、用小于0.28MPa的干燥空氣沿與吸入空氣相反的方向吹,噴嘴與折疊紙少相距25毫米,并沿其長度方向上、下吹。 3、如果濾芯上有油脂,則應在溶有無泡沫洗滌劑的溫水中洗泥桿 保定古箏 塑料增韌劑 拱形護坡模具 保定空調維修 托輥生產線,在此溫水中至少將濾芯浸漬15分鐘,并用軟管中的干凈水拎洗,不要用加熱方法使其加速干燥,一只濾芯可洗5次,然后丟棄不可再用。4、濾芯內放一燈進行檢查,如發現變薄,針孔或破損之處應廢棄不用。 The function of air filter is inhalation of dust in the air was cut off in the filter, in order to avoid compressor was premature wear and oil separator is blocked, usually running 1000 hours, or a year later, to replace the filter element, in dusty areas, is to replace a shorter time interval. When the filter is repaired, it must be shut down. In order to reduce the parking time, a new or cleaned spare filter element is recommended. The cleaning filter steps are as follows: 1. Tap the two sides of the filter to remove most of the heavy, dry sand. 2. The dry air, which is less than 0.28 MPa, is blowing in the opposite direction of air intake air. The nozzle and folding paper are less than 25 mm apart, and are blown along the direction of its length. 3, if the oil filter, should dissolve in presence of foam detergent in warm water washing, dipping filter at least 15 minutes in the warm water, and washed clean water carry of hose, don't use heating methods to make it speed up drying, a filter can be washed five times, and then discarded cannot reoccupy. 4. Put one lamp in the filter core for inspection. If it is found to be thin, the hole or damage should be discarded.